how do we select a copper power cable for a 10 HP, 1440 rpm,
440V, 3 phase AC motor?
- 4 Answers
- 11215 Views
- Rolling Mill, I also Faced
- E-Mail Answers
Answer Posted / sudhakar
depending on the current rating of the motor only we will
choose the cable rating and consider the current density of
the copper also important
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
What does a Bode plot tell you?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.
what is the meaning of WYE and DELTA in Electric meter?
What happens if the series current double?
How to measure size of cable on a given load
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
What is the permissable nutral current of three phase system as per IS standards?
what is fault level of power system ?
What are the material used for resistor?
How can we checked Killo Watts of Motor & Alternator?
