Interested to Buy Any Domain ? << Click Here >> for more details...
in 5 mva transformer 33/11 kv s/s what rating of capacitor
bank is required & what is the fourmula for rating
- 6 Answers
- 15568 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
Since you did not give the power factor there is no way to
determine the capacitor size.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
please explain to me how to calculate current,voltage,resistance with formula??
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
why moisture formation found in XLPE Armoured cable outer sheath
What are safety device in vcb and acb?
How much ph is maintained of water resistance starter for slipring induction motor ?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
How does an oscillator differ from an amplifier?
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
What is the unit of attenuation?
Can double compression glands be used with regular cables?
if we have 320KVA Genset kindly advice how much load we can put it.
Why reactive power is needed in a power system? How is it being absorbed or delivered by alternators? For reactive power control we are changing excitation but reactive power absorbing or delivering related to stator. How these two are interlinked? i want a detailed explanation with necessary expressions and figures?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
