why in large rating C.T.s equipotential wires are used?
Answer Posted / reddy
i think it is generally used to discharge current
transformer generally in case of window type cts where in
bar type it can be discharged as it was connected to
circuit itself
Is This Answer Correct ? | 4 Yes | 7 No |
Post New Answer View All Answers
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
what is the control circuit for operating the clean room air shower
What are the basic elements used for modeling mechanical translational system?
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
What is steady state response?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
What is reactance, reluctance,capistance, pls give answeer in hinglish and be simply Jo asani we smajh m aa jaye
excitation limit of an excitor
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
What is the role of feedback in a closed loop control system?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
HOW TO CALCULATE EARTHING SIZING?
How to calculate multiplying factor of dc energy meter
How maesure earth neutral value & how much maximum value value required in between earth & neutral.