Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the earthing resistance of an industrial
substation and also What should be the house hold earthing
resistance?
- 20 Answers
- 112302 Views
- Jindal, Pharma, TAAT, TATA, I also Faced
- E-Mail Answers
Answer Posted / ramkumar
aw per IS it should not be more than 1 ohm.
| Is This Answer Correct ? | 137 Yes | 28 No |
Post New Answer View All Answers
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
Electrical 'C' license full abbreviation , and full form
What is lighting kitts.
How to set the relay,,??
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
what are the range of memory address in plc for L&T lx7 4A
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
hi there i am highly enthusiastic about discussing electrical concepts , and hence i wud lyk to invit al do intrested to join me at gtalk and hav a dscussun of the concepts , ad me as a freind . my email id is rakesh.2k99@gmail.com
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
What is Bolted fault?
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
