Interested to Buy Any Domain ? << Click Here >> for more details...
How much voltage we get between two wire of 4 to 20 ma
output? Is this voltage up or down respectvice to 4 - 20
ma ?
- 9 Answers
- 14519 Views
- I also Faced
- E-Mail Answers
Answer Posted / sagar
Between two wire of 4 to 20ma signal always we get 24 valts...there will minor change in it during 4 to 20
ma variation..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
field bus transmitter calibration procedure tell me
it is possible to check the fail safe condition in pressure transmitter. if possible how?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
please send the sample qustion paper for iocl written test ..
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
Give 2 application of quartz crystal used for process parameter measurement.
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
