Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / lavanya
COMPARISON ELEMENT WITH STANDARD ELEMENT.THE CHECKING
PROCESS IS CALLED CALIBRATION.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
What do you know about gail?
What are the type of bonnets in the control valves?
what diffrence b/w plc s7200,300,400
Calibration procedure for Electro magnetic Flow meter
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
what is your eligibility criteria for freashers?
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
How process line mpm calculation is done?
line up procedure for dp type flow transmitter?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
ORP sensor working principle?
what is actual drum level and compensated drum level?
