Interested to Buy Any Domain ? << Click Here >> for more details...
what is DG synchronization panel
plz explain the working!!!!!!!
- 12 Answers
- 98297 Views
- Kirloskar, Lanco, MPS Techologies, Sedemac, I also Faced
- E-Mail Answers
Answer Posted / presidents
A DG synch panel is an electrical circuit which controls the
functionality of DG sets. 2 or more DG are sets may be used
parallel in order to share the total load of system. In
synchronization 2 or more DG sets are working in parallel
and their supply transferred to main load via a single bus
to allow this we use synchronization in which we math all
the vector groups for this we only require to match voltage,
frequency/speed(for proper load sharing),phase sequence,
phase angle. when these parameters are matched under a
defined level then only synchronizing is done otherwise it
could be hazardous and only a specialist should do it in
order to gain max. performance.
| Is This Answer Correct ? | 36 Yes | 8 No |
Post New Answer View All Answers
How many types of circuit loads are there in a common electrical circuit?
what is electrical machines
what is the role and fuction of automatic transfer switch in rotary ups
what transformer we used normally and upto which kva?
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
what are all the components required to assemble solar panel other than pv cell?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
What does bode plots shows?
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
For overhead protection we use which transformer?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com
how to test and calculat the head and discharge in borewell compressor
What is sensitivity of a measurement?
