Interested to Buy Any Domain ? << Click Here >> for more details...
what is the ratio of steel and concrete to use in slabs ,
beams, columns ?
- 5 Answers
- 90715 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / a
the ratio of steel and concrete to use in slabs ,
beams, columns are best grad is 1:1.5:3
| Is This Answer Correct ? | 38 Yes | 39 No |
Post New Answer View All Answers
How to calculate the quantity of cement mortar 2" for mosaic tile fixing 12"x12"?
do we consider shrinkage factor for calculating cement consumption for CM mixes for different works?
In block work seawalls what is the purpose of slip joints?
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
where will be the reinforcement of slab placed when there is an inverted beam and the bottom of the beam and slab are at same level ?
Could you please give me an answer to the mixing proportion of concrete M1 grade (sterngth of 1 MPa)?
what is derating factor in cable? what does it mean if derating factor is high/low in terms of thermal resistivity of soil?
how many digree of freedom in four bar chain
What is an object snap mode?
what is anchorage length,lap length and (dont remember the last one)
How is the strength of cement measured?
What is the largest concrete dam in the world?
Wats the formula of eccentric footing and how was calculated from concrete qty
what is the maximum number of course that can be laid according to IS code and the max height.
How to Know that veriation acceptable in CPWD Work Of 1:6 Cement Mortor Received Lab test report.
