Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bunny
Suppose the range of process variable is
(0-150)PSI.So when the input is zero,the value in
instrument,say a transmiter connected to measure the
pressure,will shows 4mA.This is live zero.i.e,even if the
input is zero,output has some value.
Lets assume the instrument is faulty or the
power supply to the instrument is cuts off.Then it will
show zero reading.This is called dead zero.i.e,when the
instrument is faulty,it will shows the real zero value.
| Is This Answer Correct ? | 37 Yes | 3 No |
Post New Answer View All Answers
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
How can you add value to this Industry if offered the job?
How to erection of DCS Panel at site step by step
What is three element drum level control system why its better than single element?
Tell about your IFFCO plant visit.
kindly sent some demo question and answer
why we are using magnet for calibration of gas detector?
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
Instrumentation Safe Guarding test. How to determine the interval time of the test. eg:Halfyearly,Every year,Every three years etc.
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
how to check earthing,what is minum ohms for proper earthing
, Instrument Index, P&ID review, I/O schedule, datasheet, DCS / Analyzers specifications, loop diagrams, hook-up drawings.
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
