Interested to Buy Any Domain ? << Click Here >> for more details...
What kinds of decision are made about CT from it's Knee
point(voltage & current)?
- 2 Answers
- 5197 Views
- I also Faced
- E-Mail Answers
Answer Posted / raj
For Protection CTs knee point voltage is always high than
Metering CTs to avoid saturation of CTs during fault
current.But to increase the knee voltage core size should
be increase which is practically possible or economical so
another method to reduce the burden on CTs by using
secondary ratio 1A inplace of 5A.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
percetans
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
what is counter poise conductors
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
how do you test tachos and servos
how tto ingress mw in turbine explain.procedure ?
why using transformer and thyristor switch in 3 phase apfc panel
Can you explain about Restricited earth fault protection scheme
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
how the aircraft outer body and inner body is separated ?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
transformer phasor diagram under load explain it?
