Interested to Buy Any Domain ? << Click Here >> for more details...
what happen if we supply 220v dc suppy to the bulb or tube
- 2 Answers
- 5441 Views
- I also Faced
- E-Mail Answers
Answer Posted / nishant2110
Bulb : bulb will glow as usual. Since 220v of ac is rms
value. 220v of dc will produce same resistive effect
(heat) as was produced by 220v ac.
Tube : Tube will get damaged since DC won't be able to serve
the purpose of choke coil, choke coil works with ac
only. No back emf will generate to reduce the voltage
across tube
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
what is the safety points of vaccum circuit breaker.
how can i reduce sparking without stepdowning the voltage
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
Mention what are the different colors on wires indicates?
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
What cmos is and its benefits?
which is the best institute for PLC,SCADA,DCS in hyderabad
What are the weight of 800KV DA,DB and DC type tower ?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
how calculated Transformer losses.
