what happen if we supply 220v dc suppy to the bulb or tube
- 2 Answers
- 4405 Views
- I also Faced
- E-Mail Answers
Answer Posted / hareesh
WHEN DC IS GIVEN TO BULB IT WILL GLOW VERY HIGH AS COMPARE WITH WHEN DC IS GIVEN FOR SAME 220V. BECAUSE BULB AS RESISTIVE LOAD POWER CONSUMTION DEPENDS UPON RMS VALUE OF VOLTAGE AND CURRENT.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
generally in LT and MV motors we are using 3.5Coresx16,25,35,50 etc cable for supply.although motors is earthed at two point and having all protection.then why we are using that 1/2 core for earthing the motors.while in HT cable we are using only 3core cable for motor supply.generally lt and mv motors are delta connected and ht motors having star connection.whethere it is having any relation with winding connection( star or delta).all motors i am talking about are dol only.can anybody solve my confusion.thanks...
What is the minimum underground tank size capacity considered for firefighting purpose?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
what is the formula for hv test for cable and circuit breaker..????
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
Describe the colour rendering properties of i) tungsten filament lamps ii) tubular fluorescent lamp
What is the formula to calculate distribution transformer De-rating on iron losses basis
how we select ac fuse rating of an power inverter???
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
along with technical test papers
