Interested to Buy Any Domain ? << Click Here >> for more details...
Sir We have a REF relay connected to 10MVA(Y-Y) Transformer.on
External earth fault REF relay trips along with earth fault
relay.The REF relay has no complant as we tested relay.Why is
it happening?
- 3 Answers
- 6505 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The NCT is responsible..The ungrounded lead from The NCT may
be grounded.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why do we not use equivalent voltage source in negative sequence equivalent ckt.
State ohm’s law?
how many types are their in switchyard or substation(like D,I TYPE), what is differant between them
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
Y phase plates are used in transmission line??? what is there need???
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
What is current & voltage ? Voltage perform at any load without current or not?
Why in ESP Positive earthed
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
what is V.L.F. testing of power cable? do you know the voltage ratings, like for what rating and size of cable what rating of V.L.F. testing is used?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
What is the method of estamating of cable, CB,MCB ?
How to calculate VCB rating for 33KV ,25 MW Power line?
why the projects getting loss?
