Interested to Buy Any Domain ? << Click Here >> for more details...
If the circuit breaker will not close or it will trip, what
will you do?
- 3 Answers
- 6772 Views
- I also Faced
- E-Mail Answers
Answer Posted / asif khan
I can follow below trouble shooting steps,
check the error code to see if there was any short ckt or
earth fault, if there was (check for cable termination if
the connections are not burnt out due to short circuit,
check earth resistance and current voltage etc. of the
terminals) eliminate the fault then it should work fine.
Check the control wiring of the breaker check the fuses,
contactor operations etc.
check the under voltage release to see if it did not trip
due to under voltage or over voltage. check shunt trip
mechanism.
check if breaker is not overheated as a breaker may not
close if magneto thermal release is tripped.
check closing coil operation and see whether breaker gets
charged automatically with help of the motor.
if none of the above problem found, Rack out the
breaker(keep it in isolated position)trip the breaker
manually a few times and try closing it again should work fine.
In case it does not happen you can try and by pass the
breaker with help of crocodile pin Jumpers ( In case of
Emergency), but one need to be extremely careful and should
ensure that the incomer supply to breaker is turned off
while doing it, as a high risk is involved. Also you should
be confident that breaker did not trip due to an abnormal
condition.
Note: Some breakers indicate nuisance fault as well
Further,
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is the complete procedure of erection of electrical panel in industry
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
can someone explain that how the speed of the protection system affects the fault level calculation?
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
what is the difference between general inverter and solor inverter clerly explain plz
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
How do you determine the size of transformer radiators in a transformer?
what is the responsibility of C license holder in industry?
Do u know any one? how to find out in motor rated amps? formula?
how to calculate the no load current in transformer?
what is mind in cable
What is the formula to calculate the rating of a three phase air circuit breaker
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
