Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / devendra_kushwaha27
Live Zero means 4MA
Dead Zero means below 4 MA
| Is This Answer Correct ? | 26 Yes | 12 No |
Post New Answer View All Answers
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
the output of the common trasmitter protocol in qatar gas are the following
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
How to Calibrate Flammable gas detector in field
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is the use of gauge?
What is cut off relay? And why use in PLC and DCS?
key phaser where is use and work
what is insdustrial vibration.who it works. give atleast 2 types of insdustrial vibration
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
How to Calibrate Ultrasonic Level Transmitter in field
