Answer Posted / pillay
DOL starter means a Direct On Line starter, where the AC
supply is directly applied across the motor terminals
whenever it is used unlike some bigger motors where the
power supply goes through a starting system to enable a
smoother start or a reduced current start.Some examples are
star delta ,auto transformer starter ,rotor resistance
starter, soft starter etc.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Ratings of power transformer,Distribution transformer.
1.how many types of relays? 2.difference between ATS& STS?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
importance of reactive power management
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
What is line resistance of cable & how it can be measured ?
operation of protection relay watchdog contact?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
What are the advantages and disadvantages of open loop control system?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
What is the use for cable entry in control room?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
What is difference between isolator and circuit breaker?