why we are using in ph calibrations ph4,7,9.2 buffers only?
- 5 Answers
- 17904 Views
- Reddy Labs, I also Faced
- E-Mail Answers
Answer Posted / pankaj punjabi
Calibrations not limited to 4,7,9.2 it's should cover ur
analysis range i.e. minimum to minimum and higher to higher
( 1.68-12.45)
| Is This Answer Correct ? | 23 Yes | 3 No |
Post New Answer View All Answers
for which product require to do content uniformity? what is limit of cu?
Principle of single pan analytical balance
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
what you do when compound having dwel wavelength?
what is the difference between potentiometric titration and karl fischer titration?
How to calibration of the uv spectroscopy and its test?
How to set analytical specification for combination products?
WHY given much noise PDA dector then VWD Dector
How do we fix the sample concentaryion in hplc method development?
how you start RS method development when for new product?
How we choose the mobile phase for method development.?
Why sometime potassium ortho phosphate mix with acetone use for sample preparation for hplc
which situation gc hs and gc als require to use?
How to know the estimated LOQ concentration in ppm
what is mean by ambient temperature?
