1. what is usage for power factor in industries??
2.why we need to monitor power factor??
- 4 Answers
- 6752 Views
- Havells, I also Faced
- E-Mail Answers
Answer Posted / aashish
pf is maintained to close to
unity....to avoid leading pf
operation when lightly loaded....to
save enrgy monitorng is necesary..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
What is meant by coupling capacitor?
gas turbine genrator reactances
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
what sort of general awareness questions are asked in o.n.g.c entrance exam?????????????????
What is the formula to find out two phase active & reactive power
What is different bewteen low or high impedance busbar protection scheme
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
What is cathode ray oscilloscope (cro)?
hello friends this is krunal here.. i have applied for he officer train in hpcl electrical stream.. any one who have applied before for electrical stream please help me out.. post ur reply to my mail id: krunal_airforce@yahoo.com.. any tips, old questions for paper or any help will do.. plz help me.. your faithfully, Krunal Darji
how can you calculate fault level ?
What is thresh hold value of current?
why the rotor current becomes in steady state during high slip region? please verify with equations.
PIU how does work?
