1 + 1 + 1 + 1 + 1 + 1 + 1 + 1 + 1 + 1 - 1 + 1 + 1 + 1 + 1 +
1 + 1 x 0 = answer??? pzl tell the rite answer ??
- 23 Answers
- 20395 Views
- I also Faced
- E-Mail Answers
Answer Posted / venkatesh
14
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
how to calculate the mortar for 10'*10' size room for both plastering and for masonry work?
How much Tolerance factors like 1. brick work 2.plaster 3.painting 4.floor tiling 5.wall tiling 6.shuttering 7.concreting 8.steel
i have four storeyed rcc building.basement of the building is around 34 years old.it does not have pillar support.it is having lintel steel support at every 7 feet of construction. how long this building will lost long . can any body help me in this regard
What is the life of anaerobic Digester if it is used for municipal solid waste digetion.
Wats the formula of eccentric footing and how was calculated from concrete qty
What is diversion tunnel in a dam?
What is the coeffiencent Friction Angle between Steel and Ashphalt?
how many minimum admixtures are used in water froofing structures
What things you need to take care of before building a kitchen island?
Special thing in designing a overhead reservoir ? which is different from an ordinary design
What is type failure of road surface? how to repair the failure of road surface?
what is meant by csr in foundation? what is sbc?what is meant by contour line?
For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?
What are the points to be considered for calculating cement reconciliation. a)Do we need to deduct the wt of cement bags b)Do we need to adjust the qty due to wt loss during transportation, loading unloading etc or else each bag can be considered as 50 kg bag c)What is the proportion of mix cover block making.
in design case of structural member best suitrable percentage of steel limit is what
