Which one is the Best protocol- Static routing,
RIPV2,EIGRP,OSPF.
Answer Posted / vinod
Friend I saw all answer. I m a CCIE person. I hv taken lots
of interview. 1st understand the qust. Jitendra says eigrp
bekoz router consider logest match. many says static. But
friend its nt qust. that wht router will consider best to
forward packet if its configure with static or diff dynamic
protocols. Qust is simply which is best amongst them so the
answer is
1) If u r network is small and u r router is low resources u
will use static its best for that condition. and
If u r network is huge and Routers are with High Resources u
will use dynamic. So best protocol is depend on in which
condition u r using.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the attenuation?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
What is hold down time formula of ospf?
What are the different layers of osi model?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
What metric does rip use? How is the metric used to indicate an unreachable network?
Which type of transmission bus topology support?
What is the size of hello packets in eigrep protocol?
What are the different types of the password used in securing a cisco router?
Define the virtual path?
How many broadcast domains are in switch?
what's the difference between Symmetric and Asymmetric cryptosystem?
Why we used Virtual MAC in GLBP
What is 100BaseFX?