Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / amrit goyal
dcs is distributed control system to control the process of any industries. its a controller and distributed the control signal throughout the plant.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is piezoelectric transducer?give an example in power plant n state its principle?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
what is the input of digital counter during the the calibration time?
What is instrumentation control?
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Why even multiple power supplu r used in instrumentation system?
What is eddy current? Describe the operating principle of proximity probe.
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What are different types of cable?
What are de-saturators?
how to control pid
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
