Interested to Buy Any Domain ? << Click Here >> for more details...
Tell the details of the precommissioning tests that are
performed on distribution transformer, power cable and
switchgear (11kv).
- 1 Answers
- 3912 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / subaharan
first check the transformer bushings and their condition,then
you meggering the transformer each phase to phase and phase to
earth.
power cable you check the high voltage test which is used for
measuring the leakage current,meggering and continuity
checking.
switchgear the same meggering,isolator checking,relay
testing(set various values of currents,voltages and set time
for tripping) make the fault and note the trip time.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
I have finish diploma electronics and five years experience in electrical field in ht service how can i get c licensce or other electrical certificate
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
Is vtg is controlled by the resistor? if else how much?
hr round
Disadventage of cable-gland earthing if any ?
Should power factor be low or high?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
Explain Even and Odd signals?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
Define cuttoff frequency?
