Answer Posted / bosky babu
As the Induction motor works on induction principle. that is if we give supply to the stator a voltage is induced in rotor, as the rotor is short circuited a heavy current is flowing thorough the rotor conductor,thus a torque is developed in it and it starts rotating.
Instead of giving supply to stator, if we given the supply to rotor windings by using carbon brushes, we can get the induced voltage in stator.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
List of equipments required foe industrial repair lab.
How to calculate energy stored in a capacitance
What Is HO factor in power selection
State angle criterion.
explain with diagram how to protect transformers and substations from over current with help of CT's?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
which type of questions asking for solar companies?
difference between crane drive and line drive.
Why colled 440V to 3-phase supply.
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
what do w do when the output of generator is fluctuating?
how is control wiring coding is done in a CRP panel ?
Explain how you decide what size of electrical wire do you need?
