Interested to Buy Any Domain ? << Click Here >> for more details...
i have a bar of 36 dia in column, what is the lap length?
- 12 Answers
- 23025 Views
- RMC, I also Faced
- E-Mail Answers
Answer Posted / irwin
Since the 36 mm dia bar is subject to compression, hence the the formula for the required lap is L=37(d)
where;
d=36
L=37(36)
L=1,332 (minimumn required lap for compression)
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what is the steel difference between np-2 and np-3 pipes and weight also
Define What is passive earth pressure ?
Rate analysis for construction of a solid block masonary of size 400x200x200 in C.M.1:5 in superstructure .Compressive strength 5.00 N/Sq.mm Confirming to IS: 12894:1990, with necessary scaffolding, raking of joints and pointing the same. I require rate per Cum.
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
pls mail some more tecnical qustions at msaranya2610@gmail.com
What is the use of offset command?
how to conversation of all construction material in to brass
what is the proper procedure in conducting a california bearing ratio penetration test on soil on cbr machine?
what is the water cement ratio? how to calculate it? list the wt. of constructions materials including concrete both ordinary and light wt. concrete
how u design STAGING for Superstructure in BRIDGE construction?
about higyway engineering
1.Why we are preferring 43 grade cement than 53 grade cement. 2. Approximate cost difference between 43 and 53 grade cement. Thanks.
how to diffenentiate the fixed beam and simply supported beam in the execution while reading the drawing and how the reinforcement detail will be differ for the above.
what should be RCC material i.e iron rod(mm)x cement x stone x sand for laying of slab L 42'x B 22'x tk 0.375ft = 1nos & column of H 17'x15"x8" 2nos.
what is meant by shear center?????
