Interested to Buy Any Domain ? << Click Here >> for more details...
Why the Transformer Nuetral is grounded?
- 10 Answers
- 27519 Views
- Infosys, Khartoum Refinery, I also Faced
- E-Mail Answers
Answer Posted / m fiaz javed
We are ground to neutral of a transformer because we give a
earth protection is opperate in any fault so we ground the
neutral of transformer.
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
What is meant by Load Encroachment in OHL Feeder Protection?
if we have 320KVA Genset kindly advice how much load we can put it.
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
Define closed loop control system.
How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?
What do you mean by Frame 5 Gas Turbine as well as Mark II.
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
which pump used in STP
if a number of plc s are there then how many modbus to be used
Leakage current,un balance current which relay using for high voltage transmission?
