Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between compaction and consolidation?
- 4 Answers
- 9598 Views
- I also Faced
- E-Mail Answers
Answer Posted / ved prakash singh
compaction is a process in which we remove the air voids
with the help of mechenical or manual means and
consoidation is a natural process in which intraped water
in soil voids remove with passes of time.
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
IN Compression testing machine 1division =10KN ,then what is compressive strength of 100*100 mm cubes at a load of 320 KN
what is the soil bearing capacity for a 5 floor multistorey residential building and which type of soil ? what is plinth beam? in wall load calculation center to center column distance is considered or not/
roll of DLC in road constructions
how do you calculate the quantity of steel,cement for plinth beam. (example size 41'*0.58'*1.08')
can any one explain bar bending schedule of bems and columns and slabs ??
If we are providing concrete joint in every 10m with water stopper in water tank wall then is it necessary to cut the steel at joint section?
I need to do a Compressive Strength Test for a specimen made of Rubber. Before doing the Test on the Machine, I need to have an idea of the Minimum and Maximum Compressive Strength or Yield Strength of the specimen. How can I calculate that?
What are the methods in tiles flooring ? What are the methods in brick work? What are the methods in plastering ? What are the methods in wall tiling?
Define block?
how much repeitation for conventional and maivan formwork?
Kindly post me previous year interview questions with answer for post of Manager (civil engg.) for NTPC, IOC , GAIL etc. I have interview on july 2013.I will be very grateful to you. Please guide me.
Which purpose we use deck anchor in bridges?
why the cracks occurs in NP3 class Hume Pipe ? And what is bearing capacity of it?
57. Calculate the volume of a truck loaded with stone chips whose data are as follows– 5 Top Length - 13-9, 13-10, 13-09 Bottom Length - 13-11, 13-10.5, 13-10 Top width - 8-7.5, 8-8, 8-7 Bottom width - 8-7, 8-8, 8-7.5 Depth - 2-0, 1-11.5, 1-10, 1-11, 1 -10.5, 1-11.75, 1-11
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
