Interested to Buy Any Domain ? << Click Here >> for more details...
What is the design mix? What is the proportion for M25,
M35, M40 concrete mix.
- 9 Answers
- 27497 Views
- ACC, DBM, Era Infra Engineering, Thakural Constructions, I also Faced
- E-Mail Answers
Answer Posted / kdg
if it is design mix, then the proportion can be known only
after establishing the design mix.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
What are the different types of civil engineering?
Suppose a new brick wall is being constructed,and the courses and not aligned horizontally,what negetives can it cause?
What things architect have to take care of before starting any project?
The 4 main factors to start a construction project are––
What is the difference between Fe 500, Fe 500 D and Fe 515.
How to find permissible diagonal tensile stress in reinforced brick work
Define What is the tensile strength of wood?
what is the quantity of block work required to construct a compound wall of 6" thick,and 212 lenght
how to nfind out the specific gravity of sand.aggregate,water please help...
difference between trapezoidal and pedestal footing and how the load acts on that
what is the painting co efficient of slope roof tiles?
Requirement of cement, and steel 1:2:4 ratio concrete in 1128 Sqft area(Cement No of bags, steel in Kgs)
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
Is it possible to make a feature using an overdefined sketch?
what is the clear cover for shearwall?
