We are having Chemical earthing pit
the voltage between neutral to earth showing 22V how to
solve that
- 4 Answers
- 6378 Views
- I also Faced
- E-Mail Answers
Answer Posted / tulshiram
Connection of your mesuring equipment to earthing strip is
not proper, First correct connection & then measure it, if
found again please shift your earthing pit postion or
fill/give more water for earthing then meassure.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
WTA used cb?
WRITEDOWN FEW RELY CODES
what is proper capacitor placement? How to evaluate capacitor size?
Why we use circular(Stepped) cross section in transformer core?
What is making & breaking current ???
In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...
Name a govt approved university which have 100% online engineering course.
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
