Interested to Buy Any Domain ? << Click Here >> for more details...
why 4-20 mA signal is preferred over a 0-10V signal
- 17 Answers
- 76034 Views
- Sofcon, I also Faced
- E-Mail Answers
Answer Posted / ribin
while transmitting current there is a less drop, while
transmitting as a voltage more drop occurs. so prefer 4-20mA
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
What is the use of each wire in three wire RTD
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
what are procedure of sox-nox calibration
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
What is the PLC configuration in Cement industry?
How flow can be measured with dp?
Explain why plc require in analog input 4-20amp & 0-10 volt?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
What is the difference bitween control net scaner and device net scaner
what is sil (safety integrity level
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
Whatis the reset ofset and control system in instrumentation
what about your moleg in pogrees with company
