Interested to Buy Any Domain ? << Click Here >> for more details...
Why CT's shall not be kept open?
- 5 Answers
- 8975 Views
- ABC, Qatar Gas, TIPL, I also Faced
- E-Mail Answers
Answer Posted / abdul moin
when a CT in connected to the transformer is for the
current reading to know the amps folowing through the
conductor. we keep the terminal close because of the
secondary side voltage will be rise. thats why when we
remove the meter for the maintenance purpose we provided a
short link for close the terminals inorder to avoid high
voltage at secondary.
i Hope this answer is satisfy you......
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
What do you mean by dependent and independent voltage sources?
Connection diagram for KW meter and Kva meter
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
WHAT IS THE FUNCTION OF SHORT CIRCUIT MAINTENANCE CT
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
What is mean by STUB protection?
Draw the circuit of clapp oscillator?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
What is steady state response?
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
What happens when ac supply is given as excitation voltage instead of dc supply
how to remover corona effect and hysteresis losses from contactor
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
