Interested to Buy Any Domain ? << Click Here >> for more details...
There is 3phase power cable from 1 point to the other point
which is 100m away. Two point equipped with power meter and
recorded 1st point is 205kW while the 2nd is 202kW and each
phase average carry 400amps. To calculate the resistance of
the 3phase power cable, is the formula using will be P=I2R?
- 3 Answers
- 5085 Views
- I also Faced
- E-Mail Answers
Answer Posted / pdbhatt69
If total loss in cable is 3 Kw hence it must be devided n
al 3 phases and hence 1 KW loss in one phase, now you can
use frmula P=I*I*R.It comes around 2.083 Milli ohm.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
why the carbon brushes are broken in srim while the motor runningtime
how pt is using
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
What is installed in PAC that is control the humidity
what is reactive power?, why its measured in VA ? is it transient behavior of system?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
what is the significance of tan&delta and how it performed in power transformer
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
what is the efficiency of thyristor
what are the problems that generally occur in power flows??
can any tell me why slope 40% and 80% is calculated in differential protection?
why we can use 1 to 5V dc
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
