Interested to Buy Any Domain ? << Click Here >> for more details...
Three phase alternators are connected in star connection
why?
- 13 Answers
- 42619 Views
- Tanfac, I also Faced
- E-Mail Answers
Answer Posted / mahfooz alam
In Star connection the Line Voltage is 1.732 times the phase voltage. As a result of which we can have the higher voltage in star connection when compared to the delta connection. Thus, to have more output voltage Star connected Alternator are used.
| Is This Answer Correct ? | 6 Yes | 12 No |
Post New Answer View All Answers
what is solkor relay and which condition it will act?
How out of step protection relay works?
What cmos is and its benefits?
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
how load of a turbo generator can be increased
How many double suspension hardware fittings are required on a double circuit transmission tower?
What is vaccum currcuit breaker.define with cause and where be use it device?
How to calculate earth wire load by formula
What is “pu” in ee?
is IS says that neutral should be brought to switch box. and this one is a recomended practice
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
what is servo motor & how does it work.
How can calculate the rating of a servo stabilizer for given a specific load
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
