Interested to Buy Any Domain ? << Click Here >> for more details...
two bolbs of 100w and 40w respectively connected in series
across a 230v supply.which bolb will glow bright and why?
- 16 Answers
- 63682 Views
- DRDO, PSPCL, Siemens, I also Faced
- E-Mail Answers
Answer Posted / harish kumar
Dear Friends,
1. When bulb are connected in series "CURRENT" is same , While "VOLTAGE" will be "DIVIDED" Across Each Ckt According to the Position of the circuit connected (As in Increase order)
2. And Voltage Is directly proportional to Light. If voltage is high than it will glow brightly and if voltage is low it will dim.
3. Now Consider V = 230v,
R1 = 40w
r2 = 100w
So P = V^2/r therefor R1 = (230)^2/40 = 1322.5 ohm
R2 = (230)^2/100 =529 ohm
So According to the OHM's Law V = IR
Resistance Directly proportional to Voltage.
so Voltage Directly proportional to Light.
Hence 40 watt bulb will glow more Brightly rather than 100w.
| Is This Answer Correct ? | 54 Yes | 18 No |
Post New Answer View All Answers
PLZ EXPLAIN THE INTERLOCKING AND CONTROLLING OF CONTACTORS????HOW CAN I DO THAT?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
what is arc flash and what are the hazards involved
What is the Resposiblity of Electrical Utility Engineer
1.4 What is meant by CT knee point voltage and how would you determine it
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
What is the most accurate way of testing ELCB?ELCB is better than RCD?
what is RFCT and Insulgard Relay & It's function?
state working of halogen lamp?
What are safety device in vcb and acb?
What is the selection process of breakers. Can any one please give a formulation on same?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
Define newton's law of viscosity.
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
what are the ''pitting rings''and how cn they be controlled in a series generator
