Explain about relays..
Can we give both AC and DC to the same relay...
How it is energising..
Explain its working..
- 7 Answers
- 12476 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / vijay
relay is nothing but contactor(no, nc), for working (coil
energise) supply we can give according to their
specification, for contact (no,nc ) we can give ac r dc but
we can not give both supply
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
Explain the difference between mmwc and mmwg?
What is zener diode? What is voltage regulator?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
I will attend an interview with GasGas company for a position of Instrument Technician ( Offshore )in next month can anyone tell me what questions they will ask. Thanks in advance.
how pressurize drum calibrated ?
what is the procedure of belt scale calibration?
Explain working principle of lvdt?
Why ac supply load cell is used? Can we use the dc supply load cell?
How r the calculation of process line mpm.
what is the calibration procedure for magnetic flow meter @ onsite
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
How d.p. Transmitter can be applied to close tank?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
