Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.sreenivasan
1.Burner management is not an analogue control system.
2.It controls the sequential start/stop of burners.
Certain burner management systems combine Boiler Trip
protection also and Furnace safeguard Supervisory system
(FSSS) is one such system used by CE/Alsthom
3. In European designs, the Boiler protection functions are
normally safety system either as SIL-2 or SIL-3. So they
cover all burner sequential start/stop, Boiler Purge etc.
under Burner Management system and MFT (Boiler protection)
is covered under Safety Boiler Protection system deriving
inputs from field and also sending and receiving signals
with BMS.
4.Generally Utility Boiler BMS and Boiler Protections
systems shall satisfy NFPA requirements to prevent
implosions and Explosions
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
why is not useing in boiler skin thermocople
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
If fire would be inside the plant which fire detector is to detected the fire.
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
How will you calibrate PID controller? explain with example.
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
what is the calibration procedure for transweigh make weigh feeder?
What is intrinsic safety mean.
How does temperature bath work? How does coil gets heated only by applying some current?
What is zener diode? What is voltage regulator?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
Why do you want to work here
whatis range of marcury filled tempereture gague
how to relay switch sense the fault?
