Interested to Buy Any Domain ? << Click Here >> for more details...
why using 4-20ma not using 0-20or why not using 1-
20ma???????
- 7 Answers
- 9038 Views
- I also Faced
- E-Mail Answers
Answer Posted / srinivasan narayanan
Most of the Transmitters output used 4 -20mA. This is because to identify whether the transmitters are live or not
if the Transmitter shows 4 mA it's a live Zero
if the Transmitter Shows 0 mA it's a Dead Zero
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
How to erection of DCS Panel at site step by step
field bus transmitter calibration procedure tell me
What is the diffrence between ff tx and non ff tx
What is the difference between modbus,fieldbus & profibus
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
what is IEC code in cables & how to selecting cables?
How the warning lamp of a charging-system is activated ?
What are different types of orifice plates?
if in a level tx height is given, how u calculate the ranges of the tx?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
How is flow measured in square root?
what is the protection system in solar turbine compressor
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
