Interested to Buy Any Domain ? << Click Here >> for more details...
in a electronic controller why we are using 250 ohm
resistance in input signal?is i/p is necessary in control
valve when we are using electronic controller give details?
- 3 Answers
- 10088 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / vishal sharma
we need 250 ohm resistane because when we need to opearte
any loop eg.line pressure control loop er need to instal
pressure transmitter in line after control valve on that
time if we instal 250 ohm resistane in controller we dont
have to need another SMPS install for 24v signl to pressure
trasmitter for 2-wire system after install 250 ohm
resistance we recive 24v output trrough controller.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
What is the purpose of the analyzer in petrochemical plant?
Explain the working of an electronic level troll.
can any send me a forbes marshall dtron 316 manual
What is difference between radial vibration and axial vibration explain in detail .
what will the sending unit in the fuel gauge utilizes?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
for oil & gas industries which zone is normally preferred? why? give its example?
What is the start up procedure of desalter
flow transmitter formula?
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
why we are using magnet for calibration of gas detector?
Hi Friends , i need one urgent help , i am preparing for M.tech entrance examination , i need some obejective questions related to instrumentation field. where can i get those ? can anyone help me pls ?
how is work pressure switch& level switch?what is the principle of this?
What is the meaning of wet leg
Which type of pressure can be measured by these elements?
