Interested to Buy Any Domain ? << Click Here >> for more details...
what type of drawing used in the field construction?
- 10 Answers
- 53604 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / said moqeem
for one structur we can use below drawings:
Structural,architectural,mechanical,electrical,plumbing and
civil drawings
| Is This Answer Correct ? | 29 Yes | 3 No |
Post New Answer View All Answers
howto calculate the quantities of material used in fly ash brick after finding the volume??
how many tonnes equals to one cubic feet?
brickwork labour rate per cum ?
Wats the formula of eccentric footing and how was calculated from concrete qty
what is meant by sustainable developement as far construction field is considered. Give suitable examples to explain the same
why top layer of block work shoud be full size if any cut block adjustable than another layer?
weight of 1 cft 10mm, 20mm, 40mm aggregate weight of 1cft course sand
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
on what basis the partial factor of safety are decided? form the load combinations
WHAT IS YOUR CURRENT SALARY
Who built the sears tower?
how to calibrate the RM 800
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
plz drive the formula d2/162.162 for the calculation of weight of steel bars????
HOW MUCH STEEL REQUIRED FOR SLAB OF AREA 23'3"*18.3"? FOR SLAB HOW MUCH DIAMETER BAR WILL USE?
