Interested to Buy Any Domain ? << Click Here >> for more details...
what type of drawing used in the field construction?
- 10 Answers
- 53954 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / ramesh
structural and architectural drawings
| Is This Answer Correct ? | 71 Yes | 3 No |
Post New Answer View All Answers
Describe Briefly The Various Methods Of Concrete Curing?
Dear Sir, I work in hydro project. I want to hire Scorpio/ Bolero on monthly basis. But how can i justified its amount (Hourly basic). Please solve my problem
Actually i am confused that how to calculate the bending moment for a semi-circular beam and curved slab.If any one have a good idea about the matter,please give the answer with a suitable example. Thank you......
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
Used Cement & Sand in 1 Square Meter or 1 Square Feet For Brick Work 0.115mm ? (1:4) (1:6)
Describe about the Pile test methods, which are used in Industrial & Multistory Buildings in general.
What do you understand by “preset” during the installation process of bridge bearings?
what will be density of a cement bag if its weight and volume are 50kg and 1.25 cft respectively???????
What is rate for brick masonry work of 1.0 m3 in cm 1:6?
Can we use concrete of slump cone in cube casting in which we have already measured slump?
Explain what is progress payment?
weight of 1 cft 10mm, 20mm, 40mm aggregate weight of 1cft course sand
Can someone please be curing period of the following according to IS codes Column beam slab brick masonry raft found. and also tell how many hours/day
what is the steel difference between np-2 and np-3 pipes and weight also
1) a)to prepare mortar for bricklaying how much amount of water should be added for its maximum strength and workability(to avoid cracks which results, when high quantity of water is added)?is their a formula or ratio? b) suppose we want to make 1:3 mortar,what is the best way to measure cement ,sand and water and how? c)time before which freshly prepared mortar should be used? d)proper way to mix and make mortar? e)when should curing start after laying bricks and for how long?and also how many hours per day? f)what is shear wall (please in terms of layman lol) bookish definisions are confusing.... g) and last,acc to codes what are max no. of course that should be laid in a day.
