Interested to Buy Any Domain ? << Click Here >> for more details...
how is the leakage current flow only through guard wire (when
guard wire is connected in the circuit)????
- 2 Answers
- 4408 Views
- I also Faced
- E-Mail Answers
Answer Posted / arvind
as guard wire has less resistance wire but some where we use g.i wire whose resistance is high but the correct answer for that should be that the current choose a path to ground which is less resistible it will go through that and our body is less conductive in comparison to the conductors
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to test IR testing & magnetic balance test
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
If we want to change a contactor of faulty one what are the conditions want to fullfil
How to calculate fault level of 11 KV system
What is shunt voltage and u v voltage witch one best
what are the basic insulation levels & what its Unit
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
how single phase preventer works ?
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
Define peak overshoot.
distribution is maximum done by a)radial b)network c) parallel d)b & c
what are the tests comes under the type test, what tests comes under routine tests.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what is the difference between switch yard to residential area.and how much required it.
