Interested to Buy Any Domain ? << Click Here >> for more details...
LADDER LOGIC
Can any body state Logic on following condition
Instructions to use 1-XIC 2-XIO 3-Output ONLY
Program
Push 1st button On - 1st lamp should On
Then Push 1st button Off - 1st Lamp Should remain on
Push 2nd button On - 1st lamp should Off and 2nd lamp should On
Then Push 2nd button Off - 2nd Lamp Should remain on.
- 4 Answers
- 8443 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandrasekarapandian
Yes it is possible with latch & Unlatch,
1 st rung NO switch 1 with latch coil(Lamp 1)
2 nd rung NO switch 2 with Unlatch coil (Lamp 1)
Parallel with
Latch coil (Lamp 2)
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
How to decrease opening & closing time of on/off valve?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
In turbine, what does term CDP, NI, NH, HSSOC, means
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
KAlman filter code for two dimension?
where proximity sensor installed on tank in loading arm application
How we calculate orifice plat size???
control panel design guidelines
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
how to measure draft pressure in transmitter pl. give its single line digram
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
