Interested to Buy Any Domain ? << Click Here >> for more details...
can we replace a pressure transmitter of range 0 to 25
Kg/cm2 by a Pressure transmitter of range 0 to 10
Kg/cm2 ?.. Will it affect 4 to 20 mA output signal which we
will feed to the PLC.
- 9 Answers
- 13594 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / trideep
If range is in b/w 0-10 kg/cm2 or with in that, then it will do..
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
How oil line flow measured?eplain about instruments used and working principle?
why we are using magnet for calibration of gas detector?
line up procedure for dp type flow transmitter?
What is shielding effect?
What is hp & mp seperator .& what is its working principle ?
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
What is the use of temprature compensation?
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
Conversions
what is your eligibility criteria for freashers?
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
what is sliding spool valves?
what are the selections available in configuring a burnout protection of a controller? thanks
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
