Interested to Buy Any Domain ? << Click Here >> for more details...
What is the right procedure for adjusting the gap voltage
of bently nevada vibration sensor?
- 2 Answers
- 15519 Views
- I also Faced
- E-Mail Answers
Answer Posted / imran mansuri
for vibration sensor installation take digital multimeter
connect on proxymeter out signal + comma (-) now insert
first your proxyprobeon sahft untill it's not touch body
you will get 0 volt output now unscrew proxy untill you
get -9.0vdc or -10 vdc equal 50 mil this is procedure that
i know
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
What is the difference between PLC and DDC?
If P will increase then what will happen with PID?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
what is performance test.need defination
Calibration procedure for water rotameters
Explain why plc require in analog input 4-20amp & 0-10 volt?
How the warning lamp of a charging-system is activated ?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
what are the selections available in configuring a burnout protection of a controller? thanks
What is intrinsic safety mean.
What is the difference between mmwc and mmwg?
What are the application of bernoulli’s theorem?
what is the responsibility of an instrument commissioning supervisor
