Interested to Buy Any Domain ? << Click Here >> for more details...
what is the procedure to isolate flow a transmitter and
flushing it?
- 8 Answers
- 42506 Views
- Petrofac, I also Faced
- E-Mail Answers
Answer Posted / mithilesh kumar
i am agree with above answer.
but here on of the important thing that
1st this transmitter is connected in process(DCS) or not,
if connected then 1st this tag must put in CALibration mode.
this facility in YOKOGAWA DCS.
without this action if this tag has been taken in
protection then plant will be trip.
then we can follow above answer.
any comment u most welcome.
good luck
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Specific gravity.
What is heating effect?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
how to calibrate 0- 150 psi presure gauge by dead weght tester
How to erection of DCS Panel at site step by step
How will you calibrate PID controller? explain with example.
Explain why plc require in analog input 4-20amp & 0-10 volt?
what is difference between HOT permit and cold permit
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
What is 3 selection available when configure the burnout protection for controller
Identification of ss fittings, pilot valves, relief valve.
how do u calibrate the vacuum transmitter if it shows more reading
How many interlocks at turbine? Plz explain briefly
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
