Transformer rating=> 15/20 MVA.Why there are two raings? What
should be the rating of the fuse at the secondary if the
voltage level is 13.8KV/4.16KV?
- 1 Answers
- 6657 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
15 MVA for one type of cooling and 20 for a better cooling
method.e.g. ON AN and ON AF or OF AF.Current is too high to
use fuses on LT side
| Is This Answer Correct ? | 10 Yes | 8 No |
Post New Answer View All Answers
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
what is different between relay and plc?
List of equipments required foe industrial repair lab.
is there any phase difference occurs while primary and secondary side mutual induction occurs?
what is the advantage of connecting capacitors in delta than in star?
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
Why do we use copper cable for HT Supply and why not Aluminium?
Explain about Dubai electrical sysaem? Explain about Dubai drinking water system? Explain about Dubai Burj tallest building Electrical,Water.etc.. maintenance system?
if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?
how to calculate transformer load?
what is the difference between droop mode and ischnorous mode in thermal powerplant?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
can anyone show me how the 3 phase power is supplied to socket outlets?
