Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / t.suganya
NO
Why starter?
When DC Motor is suddenly connected to a supply source,
it creates stresses on the armature and supply system.
Since at standstill the armature is not developing any back
e.m.f, so the more current than the rated current
and this will cause damage to the motor.
What the starter do ?
A Motor Starter is used for the smooth starting of a motor.
It consists mainly of a variable resistance placed in
series with the armature.
The purpose of this resistance is to restrict the armature
current to a safe value for starting and accelerating.
The other uses of using a Motor Starter is
· To disconnect the motor in case of an overload
· To disconnect the motor when the supply voltage fails
· To disconnect the motor when the field current is reduced
beyond limit.
| Is This Answer Correct ? | 53 Yes | 2 No |
Post New Answer View All Answers
why all the feeders are designed in a particular manner ... is there any reason for that???
Can you explain about Restricited earth fault protection scheme
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
What is self exciting?
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
What is CCT (Correlated Color Temperature) ?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
Define maximum demand?
Should power factor be low or high?
How cmd is calculated in case of energy neters
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
what is cogging and crawling
