Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between single and double
compression cable gland
- 3 Answers
- 20429 Views
- Petrofac, I also Faced
- E-Mail Answers
Answer Posted / sumith
single compression cable gland is used for normal panels and
it is not airtight.(it cant be used in flammable areas)
double compression cable gland is used for air tight panel i.e
purge panels(used in flammable areas)
| Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
How ejector(or)evactor air pump is working in thermal power plant?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
Explain the use of hair spring in the pressure gauge.
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
how to calibrate steam control valve in steam turbine
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
how the arrangement of equipments done in control room
How to calibration a control valve?
what can of fault ofently come in vibration mesurement?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
How to convert milliampares into flow??
draw shematic diagram of c/v positioner(smart type)?
