in a plug point why the hole size at the top is large?
- 9 Answers
- 11458 Views
- Bhel, TCS, I also Faced
- E-Mail Answers
Answer Posted / krishna r
if there any short occur, the heavy current will pass
through in that top point. its size is large because it
should be low resistance, according to resistivity = RA/L,
ie, Area is inversely proportional to resistance. so if area
increases , resistance decreases.......... please reply if
you find answer wrong .....
| Is This Answer Correct ? | 61 Yes | 12 No |
Post New Answer View All Answers
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
do we use neutral grounding for resistive balanced load? if we use what happen?
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
which type of questions asking for solar companies?
boiler is running in rankine cycle and deisel generator is....?
how did the testing of protection relays done through current injection
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
my diploma certificate in my higher education college
Explain about Dubai electrical sysaem? Explain about Dubai drinking water system? Explain about Dubai Burj tallest building Electrical,Water.etc.. maintenance system?
what is the acceptable limit value for Desolve Gas Analysis/
what is the use of expulsition protective gap in 11Kv line.
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
What is real time power factor control panel(RTPFC)?
