What is the effect of leading power factor for power
transformer & D.G?
Answer Posted / ramesh kumar gupta
Leading power factor does affect the power Xmer within its
VA rating but it affects the D.G./a Generator unit.Due to
leading power factor the source excitation system runs in
under excited state and the deficit in excitation has to be
supplied by stator.Owing to this stator end core heating
problem observed.
Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
How to calculate that clean water supply in one Day from 150 KLD STP?
what is KA rating and how can we choose switchgears on applications
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
how slip power recovery system work
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
how is the magnetic current test is different in delta-star and delta delta transformer.
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?
how calculate gd2 of ht motors
how will we calculate the copper wire load..
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
Define relative stability.
what is the difference between unarmoured & Flexible cable? How to identified?
for opening electrical shop, tips needed.