Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 357621 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / sunny
ELETRICAL MEANS DISSCUSS ABOUT THE LARGE INSTRUMENTS LIKE
GENERATORS AND TRASFORMORS,WHERE AS ELECTONICS IS DISSCUSS
ABOUT SMALL EQUIPMENT LIKE BULB,TVETC
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
In dc ckt. 24v or 110v, which one is more efficient and why?
Can a generator runs after getting 1st stator earth fault.
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
What is the formula to calculate a three phase alternator
What is meant by short-pitched winding?
how to do the ductor test?
What is the use of Surge Capacitor in LAVT?
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
Where servomechanism is used?
what is the concept of directional power?
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
